Ready install information
This table lamp install work is not very hard,just need ready some accessories.
Lamp shade,lamp harp,lamp finial,lamp holder,bulb,lamp harp accessories,lamp base,wire,plug,lamp base accessories.
Lamp holder usually have USA and EU standard,need check before you install.
Bulb also have many sizes,need check with lamp holder before you install.
Wire usually have USA and EU standard,also need check before you install.
Plug usually have USA,EU,UK,Australia standard,need check before you install.
Lamp finial need check size,confirm fit lamp harp.
Lampshade also have many sizes,need check with lamp finial and lamp base.
Lamp harp and lamp base accessories need check before install,can’t less .
Install method
Regarding the installation method, because there are many parts of the desk lamp, there will be many installation sequences. Today, only one sequence will be introduced.
First, we install the lamp base and lay the base flat. Put a dental tube suitable for the height of the base into the base vertically, and fix the dental tube at the bottom with a nut.Pass the end of the wire with the plug through the end of the base, from bottom to top, until it comes out of the top of the base.
Then use a plastic lock to fix the wires at the bottom of the base, fix the dental tube and the wires with a nut on the top of the base, and cover the dental tube with a metal cover. This completes the installation of the base.
The next start the installation of the lamp harp and lampshade.
Connect and fix the small metal base and the dental tube, connect the lamp harp and the small metal base with a short screw tube, and fix it with a nut to ensure that the lamp harp is stable.
Pass the wires out of the dental tube, confirm the positive and negative poles of the lamp cap, and connect the wires to the positive and negative poles. Then place the lamp holder on the lamp harp and fix it with screws and nuts to maintain balance.
Put the bulb into the lamp holder and turn the knob, install the bulb.
Put a suitable lampshade on the lamp harp, and then fix it with a lamp finial to complete the installation.
Turn on the power supply, connect the plug to the power supply, turn on the lamp head switch, and the table lamp can work normally.
Installation note
Although the installation steps are simple, there are some points that need attention.
When installing the base, the wire must be slowly passed through the dental tube, and not too hard to avoid scratching the wire. At the same time, ensure that the wire and the dental tube are fixed to avoid abrading the wire.
In the process of installing the lamp holder and the wires, be sure to confirm the positive and negative poles. The positive and negative poles of the wires are distinguished by color. This can be confirmed with the buyer. If the positive and negative poles are installed incorrectly, the lamp will not work.
The installation process described today is just one of them. Depending on the shape and type of the lamp harp, the installation process will be a little different. If you have different opinions, you can contact us.
Learn more about QINGCHANG products
Post time: Nov-27-2021
